kdevries Posted April 18, 2014 Report post Posted April 18, 2014 I have looked every where for an answer to this problem and I have not had any luck. I upgraded from SCCM 2012 SP1 CU3 to SCCM 2012 R2. Since then I have had issues with my OSD Task Sequence. I already recreated the images and redistributed them. I have deleted the task sequence and recreated it as well. I just want to be able to deploy an image to an unknown computer without having an issue. I get the task sequence failed with error 0X8007000B, and if I try to PXE Boot again after that fails, I then get PXE boot aborted......selected boot device failed. Press any key to reboot this system. I have been pulling my hair out for the last week trying to figure this out. Can anyone help me? Quote Share this post Link to post Share on other sites More sharing options...
Kazi Posted April 18, 2014 Report post Posted April 18, 2014 Have you tried the task sequence on different computers? I had an issue similar to this once (although I don't remember the error code) and the only way to fix it was to insert the operating system disk and format the hard drive. After I did that and tried again, it worked. This happened when we were running SP1, not R2 but it still might be worth a shot. Quote Share this post Link to post Share on other sites More sharing options...
kdevries Posted April 22, 2014 Report post Posted April 22, 2014 That's exactly what I had to do. I had to start over. It worked on other computers..... Quote Share this post Link to post Share on other sites More sharing options...
