MagnumVP Posted June 11, 2014 Report post Posted June 11, 2014 I have setup Software Updates to occur following Patch Tuesday and along the lines of what this site has recommended. I noticed that when a workstation gets updates from the SCCM12 machine it shows there is "No New Updates". However, when I check for updates online (against MS Servers) there is a gambit of updates that are not being deployed. I looked at the logs and everything seemed to be deployed to the workstations as expected. However when I did a comparison of what needed to be installed vs what was deployed within SCCM I noticed that ALL of the software that wasn't being pushed out is "Not Deployable". Is there a reason for this? If so, then how can I deploy the update if it's not deployable? Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted June 11, 2014 Report post Posted June 11, 2014 They should get deployable after you downloaded the content. Quote Share this post Link to post Share on other sites More sharing options...
MagnumVP Posted June 11, 2014 Report post Posted June 11, 2014 But why are they not already downloaded? It's 4 months old and are a "required" install according to my current setup. Quote Share this post Link to post Share on other sites More sharing options...
wilbywilson Posted June 11, 2014 Report post Posted June 11, 2014 Are you using Automatic Deployment Rules to make these updated "required?" If so, it sounds like something in those ADRs is not configured properly... 1 Quote Share this post Link to post Share on other sites More sharing options...
MagnumVP Posted June 11, 2014 Report post Posted June 11, 2014 It seems as if the Severity for the patch distributed by MS is set to None only within SCCM. This causes an issues since I'm only searching for "CRitcal", "Moderate" and "Important" However, when you perform Windows Update via online, it's set to "Important". I could change the criteria to include "None" but that would pull down A LOT of data. Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted June 12, 2014 Report post Posted June 12, 2014 If it's only one update you can either add it manually to your update group (and package), or use a custom severity and use that in your ADR query. Quote Share this post Link to post Share on other sites More sharing options...
MagnumVP Posted June 13, 2014 Report post Posted June 13, 2014 It's actually 64 updates since February Patch's Tuesday. I'm going to go through the process again and make sure I didn't forget something. The Step-By-Steps here are helpful (screens are a bit different in R2 CU1) but it gets the job done. Thanks for the assistance. Quote Share this post Link to post Share on other sites More sharing options...
