Having a problem with pxe booting Error code: 0xc0000098

[itebserv]

Hello All and thanks in advanced for your help.

 

I have sccm 2012 set up and it was working great for over a year until now.

 

after a restart the server booted fine but when i try to image a computer after it contacts tftp I get a blue screen which says:

recovery

your pc needs to be repaired.

File:\Tmp\x86x64...etc.bcd

Error Code: 0xc0000098

 

I tried readding the boot image and I tried reinstalling wds but still no luck still getting that blue screen error.
on my events I see wds event 57347 Microsoft-Windows-Deployment-Services-Diagnostics

"The PXE server processed a request from a client of architecture x86x64. However there were no boot images installed for this architecture....

 

Any suggestions?

 

Thanks

[anyweb]

try redistributing both architecture boot images to your distribution points

[itebserv]

Thanks for your fast reply.

 

i tried updating the dp but still no luck.

[itebserv]

ok added the boot image that has been created with sccm to the wds service management and the computer was able to boot to the image, i could see the sccm screen but then it went black screen and rebooted the computer.

Thanks

[anyweb]

probably missing network drivers and rebooting, what hardware are you booting, is it legacy mode or uefi mode, have you added any network drivers for that hardware to your boot wim as described in this post.

[itebserv]

Thanks for the link,

 

I am getting some progress now. I was able to boot up until the sccm windows where it says system configuration is starting up.

I deleted all my boot images and created a new one.

Will check all the drivers and add if it needs one.

 

Will let you know.

 

Thanks

[itebserv]

ok so this is what I did and still no luck.

 

I deleted any boot images that were on the sccm,

added a new one and checked all nic drivers where there.

distributed the image

tried to boot but it wasn't finding the pxe boot.

I then added the boot image on the wds management under boot images.

test computer was able to boot but now it goes to a blue screen with no error but it has the command prompt open:

X:\Windows\system32>wpeinit

X:\Windows\system32>

 

any suggestions?

 

Thanks

[itebserv]

ok some progress but still nothing.

 

I removed some drivers from the image and this time it booted to the sccm screen and it was saying windows is starting up but then it went to black screen and it restarted the computer.

 

any ideas?

 

Thanks

[itebserv]

I hit f8 in the sccm screen that shows and did an ipconfig and I do have a good ip but not sure why it doesn't load the next screen.

[itebserv]

any suggestions on this?

 

I tried to re-add boot image and winpe drivers and nice drivers and still nothing.

there has to be something that I missed, it was working fine before.

Thanks