SCCM 2012 R2 Automatic client push problem

[Ktigre]

I'm trying to push out the client automatically and it is not doing anything according to the ccm.log.

 

Here's the steps I've taken:

• Automatic device discovery was enabled
• Devices showed up in the console
• boundaries were created, boundary groups setup and the option to use for site assignment checked
• the boundaries are configured using subnets
• special service account is created and part of a group that has local admin rights on all PCs. This has been setup as the account to be used for the client push install.
• Right clicking any PC and adding the client manually works fine
• Installation property is setup with site code and fsp
• ccm.log does not show any events at all related to the client push.
• checked a few client computers and none have a ccm folder so nothing is going out to them that I can see
• tried deleting a few devices and rerunning a full discovery and it did not push the client out to the pcs that were rediscovered. This was a suggestion I read in another forum.
• if I pull up the properties on a device it shows the agent site, so I assume that it is properly configured for the site assignment.

I'm stuck. I'm not sure what other things there are to try to get the automatic client push to work.

[Jorgen Nilsson]

Hi,

It sounds like it could be a firewall issue or somethng like that, anything entered in the CCM.log file on the Primary Site Server?

 

/Jörgen

[Ktigre]

Nope nothing showed up in the ccm.log Though I did solve it.

 

I switched the boundaries to IP ranges instead of subnets. I can't find any reason that it would make a difference, but once that got changed, instant client pushes.