I was thinking this for couple of days and didn't figure it out so far. Even though i am learning ZTI everyday, but sometimes it does not make any sense to me.
I use "standard client task sequence" in MDT and when my install CD loads WinPE, I format the disk drive by bringing command prompt by pressing F8. My TS runs fine with all the application i specify in the Task Sequence.
However, After i get the ZTI completed through SMS with OSD, the imaged PC gets a folder "Minint" in the root of C drive which has all the logs and some exe files. But when i try to re-image the same PC, the TS fails in Post Install phase. However, i noticed that during re imaging it skips initialization, validation, install and directly goes to the Post Install phase. But I want the task sequence to go through atleast the validation phase so that i can format the disk in that phase.
My question is:
How can i make a task sequence with which i can image a PC and re image a PC. But it should always wipe the HD before image or re-image takes place.
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.
I was thinking this for couple of days and didn't figure it out so far. Even though i am learning ZTI everyday, but sometimes it does not make any sense to me.
I use "standard client task sequence" in MDT and when my install CD loads WinPE, I format the disk drive by bringing command prompt by pressing F8. My TS runs fine with all the application i specify in the Task Sequence.
However, After i get the ZTI completed through SMS with OSD, the imaged PC gets a folder "Minint" in the root of C drive which has all the logs and some exe files. But when i try to re-image the same PC, the TS fails in Post Install phase. However, i noticed that during re imaging it skips initialization, validation, install and directly goes to the Post Install phase. But I want the task sequence to go through atleast the validation phase so that i can format the disk in that phase.
My question is:
How can i make a task sequence with which i can image a PC and re image a PC. But it should always wipe the HD before image or re-image takes place.
Share this post
Link to post
Share on other sites