Kingskawn Posted October 8, 2009 Report post Posted October 8, 2009 We did a deployment of a package (MS Compatibily Pack 100MB) to a distant location and the bandwidth was full. No business could be done anymore. They had to wait until the deployment was done or I had to stop it in sccm. So what possibilities do I have? There is BITS in clients and RATE LIMITS in addresses. I already put the rate limits in addresses from primary site to secondary site at 50%. The problem is that when I want to make a new package for everyone that it takes ages before it gets synchronized to that (problem) secondary site. Is it better to use BITS in this case such a way that the clients use bandwidth when there is available on his network cable? I hope it's clear... Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted October 8, 2009 Report post Posted October 8, 2009 When do you have the problems? Is it when the clients try to install the package or when you are distributing the package to the secundairy site? Quote Share this post Link to post Share on other sites More sharing options...
Kingskawn Posted October 8, 2009 Report post Posted October 8, 2009 When do you have the problems? Is it when the clients try to install the package or when you are distributing the package to the secundairy site? It's when the client downloads and installs the package that they can't work anymore because of not enough bandwidth Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted October 8, 2009 Report post Posted October 8, 2009 Do the clients download from the correct DP? Quote Share this post Link to post Share on other sites More sharing options...