2008 standard server with SCCM 2007 sp2 / SQL installed.
SCCMSvr
Client macnines:
ClientXP1
ClientXP2
I have installed SCCM to run in mix mode on my SCCM sever. I followed all the guidelines, installed all the prerequisites (by running the prechecker and fixing all the issues: extending the schema, installing iis, webdav, remote differental and so on...). Everything installed without any issues. I was able to go in and set my boundaries (currently set to Active Directory). I was able to go into Client installation methods and check all that.
When i go down to All systems, i do see all my systems on my network, but the issue is when i click to install client, nothing happens. under Assigned it says "Yes", but under Client it says No".
I have gone over all my documentation and i cannot figure out why this is happening. PLEASE HELP!
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.
My setup:
AD 2008 running in native mode.
Domain controllers:
PriDC1
SecDC2
2008 standard server with SCCM 2007 sp2 / SQL installed.
SCCMSvr
Client macnines:
ClientXP1
ClientXP2
I have installed SCCM to run in mix mode on my SCCM sever. I followed all the guidelines, installed all the prerequisites (by running the prechecker and fixing all the issues: extending the schema, installing iis, webdav, remote differental and so on...). Everything installed without any issues. I was able to go in and set my boundaries (currently set to Active Directory). I was able to go into Client installation methods and check all that.
When i go down to All systems, i do see all my systems on my network, but the issue is when i click to install client, nothing happens. under Assigned it says "Yes", but under Client it says No".
I have gone over all my documentation and i cannot figure out why this is happening. PLEASE HELP!
Share this post
Link to post
Share on other sites