SHASHIDUBEY01 Posted September 21, 2020 Report post Posted September 21, 2020 Hi everyone, Hope all are being safe and sound !! Need someone experience in setting up ip helpers for pxe boot as we are trying to establish the same in our environment but having some issues. Since we have our VLAN ranges and WDS server on different subnet and due to cost constraints we can’t set up a local WDS for this range we thought about going for up helpers for it . It’s already configured on switched by our network team but need someone expertise with the below : > after adding the vlan scope in our DHCP server do we still need to keep option 66 and 67 enabled or disable?? > if we implement ip helper from network side and keep the option 66 and 67 enabled at DHCP would it mess with the functionality?? Is it mandatory to get them disable?? > what are the changes we should be doing at DHCP side for this pxe boot using ip helper? Regards Shashi Dubey Quote Share this post Link to post Share on other sites More sharing options...
radish Posted September 24, 2020 Report post Posted September 24, 2020 Yes, 66 and 67 must be set to see the actual situation of the device When the number of VLANs is relatively small or when the switch setting does not support ip helper, You can set a distribution point for each vlan to solve the OSD problem. 1 Quote Share this post Link to post Share on other sites More sharing options...
SHASHIDUBEY01 Posted October 7, 2020 Report post Posted October 7, 2020 HI Radish, Thanks a lot for your reply and help !! Would try the same and hope to have your experience and expertise going ahead too Stay safe and healthy . Regards, Shashi Dubey Quote Share this post Link to post Share on other sites More sharing options...
