sothpaw Posted June 3, 2012 Report post Posted June 3, 2012 Hello Fellow Configuration Manager 2012 Admin, We recently migrated from Configuration Manager 2007 to Config 2012 Manager. I seem to be running into problems dealing with my two main task sequences when trying to kick either one off in Windows. When I try to start either the Refresh or Replace Task Sequences this is the error message I get: Unable to make changes to your software There was a problem applying changes to the software. You can try again. Or, if the problem continues, the information that is shown in the following section can assist your help desk in troubleshooting. Click OK to return to Software Center. More information 0x80004005(-2147467259) I know I'm missing something (I'll include a screenshot of the error message). Any help would be greatly appreciated. Thanks, sothpaw Quote Share this post Link to post Share on other sites More sharing options...
jbpatric Posted June 26, 2012 Report post Posted June 26, 2012 I'm receiving the same error. Where you able to figure out what the problem was? Quote Share this post Link to post Share on other sites More sharing options...
frankalbcn Posted August 30, 2012 Report post Posted August 30, 2012 Hello everyone, Any solution could you find to this? Many thanks Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted August 30, 2012 Report post Posted August 30, 2012 Please provide more information... Did you for example look at the client logfiles? If so, what did you see? Quote Share this post Link to post Share on other sites More sharing options...
