dobsonl Posted October 18, 2012 Report post Posted October 18, 2012 Hi Has anybody seen this error before when capturing a windows 7 SP1 64bit image? It doesn't seem to make any difference if I run the task sequence on a Virtual machine or a physical machine The logs dont say anything, unless im looking at the wrong one.... which could well be the case as still relativly new to SCCM Thanks in advance Luke Quote Share this post Link to post Share on other sites More sharing options...
Rocket Man Posted October 18, 2012 Report post Posted October 18, 2012 this error can happen if hardware is faulty...HDD etc.(the TS is unable to access the HDD)..but if it is happening on a Virtual Platform also then I'd say you can rule this out.....have you configured your Network Access Account? Also take a look at this http://social.techne...8b-6895fa83275c Quote Share this post Link to post Share on other sites More sharing options...
Oneone Posted October 18, 2012 Report post Posted October 18, 2012 Could you post the smsts.log file? from C:\ At what stage is this? does it format and partition the disk? Quote Share this post Link to post Share on other sites More sharing options...
dobsonl Posted October 18, 2012 Report post Posted October 18, 2012 Hi, I have checked the network access account and this is fine, i dont think its hard drive problems as the error arrives on a virtual machine and 2 different physical machines... As far as I can see it downloads the install files, then goes to the "applying image" stage then the blue windows 7 setup wallpaper appears briefly and that is where it fails, I have attached the log. Thank you for your advice so far smsts.log - just looking at why its not picked the drivers up, would this likely be the problem? Luke Quote Share this post Link to post Share on other sites More sharing options...
Iroqouiz Posted October 18, 2012 Report post Posted October 18, 2012 There's a whole bunch of driver related error messages in that log file. Have you added NIC/HDD drivers to your boot image? Quote Share this post Link to post Share on other sites More sharing options...
dobsonl Posted October 18, 2012 Report post Posted October 18, 2012 I thought I had, but looking at that now - looking as if they haven't imported. Quote Share this post Link to post Share on other sites More sharing options...
Rocket Man Posted October 18, 2012 Report post Posted October 18, 2012 Just right click on the boot.wim.....properties and drivers tab... this should give you a list of all drivers that have been added to them! Dont forget to update the DPs afterwards in the event of injecting any new drivers to them Quote Share this post Link to post Share on other sites More sharing options...
tmiller_hockey Posted December 12, 2012 Report post Posted December 12, 2012 Why would you need drivers in a Hyper-V VM? I'm having this problem as well. Quote Share this post Link to post Share on other sites More sharing options...
Peter33 Posted December 12, 2012 Report post Posted December 12, 2012 You usually don't need drivers for hyperv. Check the smsts.log for a detailed error description. Quote Share this post Link to post Share on other sites More sharing options...
tmiller_hockey Posted December 12, 2012 Report post Posted December 12, 2012 Can't get to the log. Press F8 and no command prompt even though I have command support enabled. Other ideas?? Quote Share this post Link to post Share on other sites More sharing options...
