Remote control behavior in system center configuration manager 2012

[daphanis]

Hi,

 

I have a doubt about remote control behavior and I did not found answer for that.

My doubt is when I have one primary site at the hub office, and at my branch office I have a secondary site, if the admins at the branch office use the remote control at their local network, the remote control will connect to the primary site to connect to the machine or it will connect straightaway to the machine?

 

Thanks

[Jorgen Nilsson]

Hi,

It will connect directly to the computer that you want to remote control.

Regards,

Jörgen

[daphanis]

Jorgen,

 

Just to understand at the past with sccm 07 that used to work the same, I mean if I had a secondary site at the branch office the remote control connection would connect from the branch office, or would be necessary to have a primary site at the branch office.

I'm just asking because I don't know where a read once that sccm 07 had this behavior when using secondary sites at branch offices.

 

Thanks again!