Build capture fails everytime can't figure out why!

[stevenjwilliams83]

I can deploy a standard image to a VM no problem, but build capture fails all the time. smsts.log file attached can someone tell me what I am looking for?

smsts.log

[anyweb]

Failed to save execution state and environment to local hard disk

 

diskpart your disk and create a partition on it, then try the task sequence again

[stevenjwilliams83]

Can I do this somehow without touching the PC? My deployment has disk 0 configured for 2 partitions, one is 100mb hidden, the other is 100 percent of what is left and for the system.

[anyweb]

why has it two partitions ? if it's a VM then it doesn't need a bitlocker partition,

alternatively if you insist on doing two partitions in this build and capture, and i can't see why...then make sure that the OS partition is formatted, can you show the task sequence you are using (screenshot..) for the partition disk 0 step...it should look like this

 

 

have you tried following my build and capture post here ?

[stevenjwilliams83]

I have followed your instructions to the "T", with no luck. I do want my build and capture to include bitlocker as this is a requirement for all new deployments. So that is why I created two partitions. Do I need any type of drivers for storage?

[Peter van der Woude]

Two things, one you can NOT use Bitlocker on a VM (well, eventualy it is possible with some tricks) and two you can NOT include Bitlocker with a Build and Capture (also, I can't think of a reason why you would even want that).

[stevenjwilliams83]

Ok. But I will want to automate the process of bitlocker when I deploy....Otherwise I have to go to every PC and start the process.

[Peter van der Woude]

Then just capture a "normal" image and create the two partitions during the deployment task sequence of the image.

[stevenjwilliams83]

This is what I did. And the capture still fails.