pnyce24 Posted February 25, 2013 Report post Posted February 25, 2013 I'm in the process with installing SCCM 2012 and wanted to know should I go and install SCCM 2012 SP1 (instead of SCCM 2012 "no service pack) considering the current SP1 issues I've been reading. Grant it, most of the issues I see is when admins or engineers are upgrading from SCCM 2012 no service pack to SCCM 2012 SP1, and not a fresh install. What do you all think? Thanks, P Quote Share this post Link to post Share on other sites More sharing options...
anyweb Posted February 25, 2013 Report post Posted February 25, 2013 SP1 offers so many new features that it's what i'd recommend, however be aware that the new ADK requirements means you have WinPE4 and that means that hardware older than 3 years may have problems PXE booting... until Johan Arwidmark posts his workaround Quote Share this post Link to post Share on other sites More sharing options...
pnyce24 Posted February 25, 2013 Report post Posted February 25, 2013 We are using WINPE 3.1(64 bit), and the hardware in some of our remote sites are definitely at least 3 years old. So I feel like i'm in a catch 22 because SP1 sets me up for the future(ie-server 2012), but installing it will/may cause some issues in our current infrastructure.... Quote Share this post Link to post Share on other sites More sharing options...
anyweb Posted February 26, 2013 Report post Posted February 26, 2013 I'd recommend you set it up in a lab first (always recommended) and test your hardware with it, shouldn't take too long and will reveal any problems you may/may not have. Quote Share this post Link to post Share on other sites More sharing options...
Iroqouiz Posted February 27, 2013 Report post Posted February 27, 2013 When I upgraded from RTM I experienced a lot of problems. Re-installed my site with SP1 from scratch and haven't had a problem so far. Quote Share this post Link to post Share on other sites More sharing options...
h4x0r Posted March 8, 2013 Report post Posted March 8, 2013 Sorry if this is resurrecting an old thread...I followed the information found in this link and our SP1 upgrade went flawlessly. We are however dealing with some older hardware that's not supported in WinPE 4.0. Quote Share this post Link to post Share on other sites More sharing options...
