dsells Posted July 9, 2013 Report post Posted July 9, 2013 We are new to SCCM, we are running 2012 SP1, our task sequence seems to run perfectly other than drivers. We have some models in particular (Optiplex 380 and 390s) that do not install NIC drivers, so the TS isn't finishing. By the time the TS gets to Setup Windows and Config Mgr there's no NIC so it won't finish. We tested the driver to make sure it works in WIn7 and it does. I've injected the driver into our boot img, and still no luck. I was just wondering if anyone else has run into this. Quote Share this post Link to post Share on other sites More sharing options...
SirArion Posted July 9, 2013 Report post Posted July 9, 2013 I am having this problem as well for the first time. I am importing drivers for an HP Elitebook Revolve 810 and they are successfully imported but the TS (which is trimmed down to just this set of drivers) doesn't get the NIC drivers. Dropping them onto a USB and pointing the Unknown Device in Device Manager to them and they load u p just fine. I have done 30-40 models and haven't had this issue. Any suggestions on logs (or anything) to look at to try and find out why it won't auto install but will manually? Quote Share this post Link to post Share on other sites More sharing options...
