freehat Posted July 16, 2013 Report post Posted July 16, 2013 Good day to all!Please, help me with a such problem: The clients successfully installed up to a certain point, but now they installs without any settings and don't becomes a clients for SCCM. There are only version, certificate, and connection type settings are shown in the client settings page. There are specified all the necessary parameters (SMSSITECODE, CCMHOSTNAME, SMSMP, DNSSUFFIX) In the properties of the Client Push Installation. Clients are memebers of the boundary group. At the same time the option "Enable automatic side-wide client push installation" is enabled and the clients which installed automatically have a proper settings and are active clients for SCCM. And this breaks my mind. Why they have the different settings with manually installing clients? And I also recently installed CU2, but after that the clients were installed properly for somу time. I'm not very experienced in SCCM yet and this problem is driving me crazy for over a week, so help me, please! And thank you in advance! Quote Share this post Link to post Share on other sites More sharing options...
teamfox201 Posted July 18, 2013 Report post Posted July 18, 2013 In the System Center console are these clients Approved? Do you have Automatically approve computers in trusted domains enabled under Hierarchy Settings? Quote Share this post Link to post Share on other sites More sharing options...
freehat Posted July 24, 2013 Report post Posted July 24, 2013 Thank you for your answer! Yes, Automatically approve computers in trusted domains is enabled. Quote Share this post Link to post Share on other sites More sharing options...
