janhoedt Posted October 7, 2013 Report post Posted October 7, 2013 Hi, I have SCCM 2012 SP1 with MDT, the mdt task sequence with x86 boot image works fine but the X64 does not: it starts up the udi while it is configured as zero touch(!). Please advise.J. Quote Share this post Link to post Share on other sites More sharing options...
Peter van der Woude Posted October 7, 2013 Report post Posted October 7, 2013 This is very little information.... It sounds like the UDI is still a step in the task sequence, which means that you have to check the logics of the steps (what's configured in the options tab?). Quote Share this post Link to post Share on other sites More sharing options...
janhoedt Posted October 8, 2013 Report post Posted October 8, 2013 Thanks. It are 2 identical task sequences, default. One with x86 as boot image, one of x64 as boot image. x86 works fine, x64 shows UDI wizard. If there would be something in the task sequence then both would start with UDI wizard I would think? What other info do you need/can I give you? Quote Share this post Link to post Share on other sites More sharing options...
janhoedt Posted October 8, 2013 Report post Posted October 8, 2013 Note: I added some screenshots of the ts here: https://www.dropbox.com/sh/zygunifjv88e6xp/PLTzE_V3V_ Quote Share this post Link to post Share on other sites More sharing options...
janhoedt Posted October 8, 2013 Report post Posted October 8, 2013 When I disable the UDI wizard, it works fine. But why should I disable it, it should work out of the box since I skip the UDI wizard .... Quote Share this post Link to post Share on other sites More sharing options...
janhoedt Posted October 16, 2013 Report post Posted October 16, 2013 Posts are dying here apparently. Probably better stick to Technet forum then. Quote Share this post Link to post Share on other sites More sharing options...
